Products
HT MC11 T15
Microprocessor Temperature Regulator in Table Housing
HT MC11 T15 is a temperature regulator ready for operation in a versatile table housing. It has the same regulating characteristics as HT MC11 and can be used with
different electrical heatings. The temperature supervision function using a second temperature sensor enables to monitor the limit temperature of the heating element
and to place the sensor at an important position of the component or inside the medium. In case of higher demands on control systems some helpful features can
be used, e.g. self-optimization function, output ratio limitation and programming function. The RS485 interface option and the analog input/output option are available
for communication with external devices.
Functions and features
| Housing: | Powder coated aluminum, protection category IP 30 |
| Control electronics: | Two-position-regulator, PID control characteristics |
| Self-optimization: | Automatic determination of control parameters (Autotune) |
| Operation: | Using keypad |
| Temperature supervision: | Temperature supervision with second sensor input, adjustable limit value, two-pole disconnection of heating voltage |
| Connections: | Heating and temperature sensor connection via multipole sockets or cable glands, connection board with spring terminals inside the housing |
| Switching power: | Up to 3450 Watt (at 230 VAC), electronically switched |
| Temperature sensor: | Independently selectable for regulation and supervision, Resistance sensor Pt100, NI120, Pt1000, Thermocouple Fe-CuNi (L), Fe-CuNi (J), NiCr-Ni (K), PtRh-Pt (S), NiCr-NiSi (N) |
| Potential-free switching: | Heating voltages 24-250 VAC (10 A or 15 A depending on model) can be switched independently from the auxiliary voltage of the control electronics. |
| Program function: | 6 * ramp time + hold time |
| Softstart function: | For smooth heating-up |
| Alarm relay: | Potential-free normally open contact, 250 V, max. 2 A |
| Output ratio display: | Shows the present calculated output ratio in 0...100 % |
| Max. output ratio limitation: | Reduces the connected heating output |
| Manual output ratio mode: | In case of sensor break, operation continues with last calculated output ratio |
| Manual mode: | Device operates as a power controller |
| Operation lock: | Available on three levels |
| Setpoints: | Setpoint 1, setpoint 2 (can be activated by external contact), external setpoint (only for option „analog input/output“) |
| Second parameter set: | Possible (can be activated by external contact) |
| CE marking: | EMV according to 2004/108/EG; EN 61326-1, Electrical safety EN 61010-1 |
or in stationary use.
On request, we also mount the regulator HT MC11 in other housings, depending on requirements.
On request, we also mount the regulator HT MC11 in other housings, depending on requirements.
